Measurement-supported CFD Modeling of Vapor Transport in an Indoor Swimming Pool

Authors

  • Péter Nagy-György
    Affiliation
    Department of Hydrodynamic Systems, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., H-1111 Budapest, Hungary
https://doi.org/10.3311/PPci.45830

Abstract

Indoor swimming pools require reliable control of air temperature, relative humidity, and outdoor-air supply to ensure thermal comfort, limit condensation and corrosion, and reduce the energy demand of ventilation and dehumidification systems. However, airflow and vapor distributions depend strongly on facility geometry, water surfaces, air-supply arrangement, and operating conditions; therefore, a single humidity measurement may not represent conditions throughout the hall. This study presents a measurement-supported workflow combining local field observations, operational data from four air-handling units, a Dalton-type pool evaporation model, and full-room computational fluid dynamics to analyze vapor transport and identify candidate humidity-sensor locations in a large indoor pool hall with approximately 2024 m² of water surface. At the analyzed operating condition, the evaporation rate predicted by the Dalton-type model agreed with the value independently determined from the air-handling-unit vapor balance within the measurement uncertainty. A three-dimensional ANSYS CFX model was developed in which humid air was treated as a two-component ideal-gas mixture, buoyancy was included, and turbulence was represented using the SST k–ω model. Two air-supply distributions were compared at an unchanged total supply flow rate. Relative to the 1:1 split, the 3:1 spectator-to-pool-side split weakened pool-side mixing, modified ceiling-level low-velocity regions, and increased humidity accumulation near the teaching-pool corner. The integrated workflow linked the building-system vapor balance to pool-specific CFD source terms and identified internal columns at approximately 2.5 m height as promising sensor locations because they avoid direct supply jets while remaining exposed to representative pool-space conditions.

Keywords:

computational fluid dynamics, building ventilation, humidity, swimming pool, evaporation

Citation data from Crossref and Scopus

Published Online

2026-11-17

How to Cite

Nagy-György, P. “Measurement-supported CFD Modeling of Vapor Transport in an Indoor Swimming Pool”, Periodica Polytechnica Civil Engineering, 2026. https://doi.org/10.3311/PPci.45830

Issue

Section

Research Article